Properties of JIS G3116 SG325 steel platePageviews:
Ordinary medium and thick steel plate JIS G3116 SG325 steel plate is a kind of deoxidized steel. The oxygen content of the steel liquid is relatively high, and a lot of gas will be produced during the production process to make the steel liquid boil, so it is also called boiling steel. Advantages: this kind of steel plate has smooth surface, good quality and easy processing. Because this kind of steel plate has no concentrated shrinkage cavity, the amount of deoxidizer is very small and the price is lower than other steel plates.
JIS G3116 SG325 steel plate 2020 spot size: 16*1800*6000, 15*2500*10000, 25*2400*8200, 50, 25*2400*8200, 16*2000*10713, 25*2400*8200, 16*2270*11900, 15*2500*10000, 25*2400*8200, 28*2170*13000, 130*2200*7700, 100*1770*6650, 88*3440*9200, 12*2200*8000, 8*2200*5730, 16*2320*10000, 30*2400*9680 12*2200*8000, 16*1800*6000, 50*1820*10700, 130*2200*7700.
Preheating cutting: The most effective way to prevent steel plate cutting cracks is to preheat before cutting. Before flame cutting, the steel plate is usually preheated, and the preheating temperature mainly depends on the quality level and thickness of the steel plate. The preheating method can be carried out with flame burner, electronic heating pad, or heating furnace. In order to determine the preheating effect of the steel plate, the required temperature should be tested at the heating point.
After the steel plate is produced from the original factory, it will pass through a series of transportation and storage links and then be delivered to the processing workshop. During this period of time, the steel plate surface will contact with the air continuously, which will inevitably produce a layer of oxide skin. The oxide skin is a difficulty in the treatment process. It has high melting point, is not easy to burn and dissolve, increases preheating time, reduces cutting speed. Therefore, the surface of the JIS G3116 SG325 steel plate plate should be derusted before cutting.